1.Start the main motor, run at low speed, and then adjust the side position control to halve the film in the middle position. Adjust the left and right nip rollers to align the left and right films, and adjust the front and back nip rollers to align the patterns. Adjust the heat-sealing knife to make the heat-sealing within the required range of the bag. Adjust the slitting blade to the desired position, and adjust the punching position to the scissors mouth.

2.Bag-making length adjuster: The bag-making length is adjusted by changing the position of the connecting rod sleeve on the eccentric carriage to control the bag-making length, and the bag-making size is adjusted by the elastic hand wheel and the nut. If it is found that there is an error in the length of the bag during the production process (usually after half a year of continuous production), and other faults cannot be resolved after troubleshooting, the clutch can be disassembled for inspection and maintenance.

3.Bag making and bag cutting are completed on one machine. After the materials are compounded, they are placed on the bag making machine. After the bag making machine is adjusted, the bag materials can be heat-sealed according to the adjusted size. Cut the bag according to the adjusted size. The beam roller is raised or lowered a certain distance to obtain the ideal cutting line. In order to facilitate the observation of the quality of the welding wire, the position of the welding wire of the single bottom wire can be adjusted to the outer end of the machine cutter.